THC Vape coil fit: for the EU
THC Vape sits in a crowded price band, and the cheapest quote on the sheet is rarely the cheapest unit on your shelf. Everything below is built around reorder rate, defect rate and cash conversion rather than headline unit price.
Published 27 September 2026 · VapeWholesaleHub · Reading time 7 min
What we test before a carton is sealed
Buyers come to us for THC vape after a bad quarter: dead stock on one side, empty shelves on the other. The cause is usually the same, an assortment built from a catalogue instead of from sell-through data. This page explains how we rebuild that balance for wholesale buyers.
Flavour drift between batches is the quiet killer of repeat orders. We retain a sealed reference sample from every run so a complaint six weeks later can be compared against what actually left the building.
Cosmetic grading is written down, not argued about. Minor scuffs inside the tolerance band are accepted; anything that would make a customer put the unit back on the shelf is rejected. Your staff should never have to explain a finish defect to a paying customer.
Sell-through notes for the shop floor
Staff knowledge converts better than any poster. If your team can explain the difference between two coils in one sentence, the step-up SKU sells itself.
Seasonality in THC vape products is real but smaller than most buyers assume. The bigger swing comes from restocking discipline, not from calendar events.
How the price is actually built
Payment terms for new accounts are normally a deposit with the balance against the bill of lading. Established buyers on a repeat schedule can move to terms after three clean shipments.
A landed cost sheet for THC vape has five lines: unit price, packaging, freight, duty and the cost of defects. Quoting only the first line is how buyers end up surprised at the fourth.
- Artwork proof plus physical dummy for custom packaging
- Seven-day defect reporting with replace-or-credit
- Batch codes traceable from carton back to production date
- Standing reorder schedule with a fixed cut-off
- Specification locked in writing before production starts
- Reference sample retained from every batch
Building an assortment that actually turns
Sourcing trips still matter for volume buyers. Seeing the line, the ageing room and the packing station tells you in an hour what six emails cannot. We host visits by appointment and we do not stage them.
A practical starting order for wholesale buyers is 240 units across two or three SKUs, not 240 units of one. That spreads the risk, gives your staff something to compare, and still hits the first price break.
Specification summary
| Volume | 1.0 ml |
| Hardware | Ceramic core |
| Thread | 510 thread |
| Airflow | Fixed |
| Window | Full glass |
| Packaging | Blister |
| Minimum order | 100 units per SKU, mixed cartons allowed |
| Lead time | 22 working days after artwork approval |
If any of this is unclear, the fastest route is a message rather than a meeting. Send the market you sell into and the price band you work in, and you will get a specific answer instead of a brochure.
Frequently asked
How long does production take?
Around 28 working days after artwork approval for stock configurations, plus transit. Custom runs add roughly a week for tooling and a physical dummy. We confirm the date in writing on the order acknowledgement.
What happens if part of the order is defective?
Report within seven days with photos and the batch code. Confirmed defects are replaced or credited on the next shipment. The failure is logged by mode and batch, and reviewed monthly with the factory.
What is the minimum order for THC vape?
Standard configurations start at 240 units per SKU, with mixed SKUs allowed inside the same carton. Custom colours, custom packaging or a private label run usually start at 600 units because of setup time on the line.
Related reading
Need a quotation on THC vape products?
Send destination market, target price and quantity. Same-day reply on working days.
Tel / WeChat / WhatsApp +86 13711127975 · vape@0099933.xyz